跳至主要内容

Could OBDSTAR dp plus do key program on GMC Sierra 2015-2018

OBDSTAR X300 DP PLUS PAD2 Can support GMC SIERRA 2015-2018 do key programmer
OBDSTAR-dp-plus
Here, check the car list:

SIERRA
2017-
2015
with Smart
without Smart
2007-2009
SIERRA 1500
without smart
2015
SIERRA 2500
Without smart
2014
SIERRA 3500
Without smart
2014
sierra odbstar x300 dp plus

标签：

评论

发表评论

此博客中的热门博文

How OBDSTAR X300 DP Plus Program 2016 Toyota Smart Key with NO.3 Simulated Card

  This post will present a process how  OBDSTAR X300 DP PLUS program 2016 Toyota smart key with simulated card. Car model: 2016 Toyota Tools in this process: 1.  OBDSTAR X300 DP Plus 2.  P001 Programmer 3.  NO.3 Simulated card Note: both P001 and simulated card are contains in the OBDSTSR X300 DP Plus package After connected them together, choose TOYOTA/SCION/LEXUS in IMMOBILISER. Choose “smart key system”->”type 5 (All smart keys lost)” Read EEPROM NOTE: 1. This function can read (backup) vehicle EEPROM data 2. after read (backup) of vehicle EEPROM data, the simulated card is generated with this data 3. using simulated card attach start button to illuminate instrument and instead of original car key to [Add Smart Keys] Save the file, and you could rename it in this step Appear a guide: the vehicle EEPROM data backup was successful. Please execute the [Make Simulated Card] function As the guide saying, choose “make simulated card’ Choose...
发表评论
阅读全文

Autel MaxiSys Elite and Mercedes SCN Coding

I purchased the  Autel Maxisys Elite almost a year ago. I decided to buy it from an Autel representative based on his customer service skills and YouTube videos. I am based in the USA and the Autel rep is outside the USA. I paid a bit more for the tool because the direct human to human customer service is something I value a lot and it is something nearly extinct nowadays. Total price was $3600 USD and it was equipped with an additional cable for BMW programming and the nifty camera too. The Autel marketing practices do very little to bring clarity to the details of what the tool can and can not do. When it comes to programming various modules found in our vehicles, the details are lacking. It can program BMW and Mercedes Benz from the tablet, but it can not program GM modules because the software to program GM runs on Windows, not Android. However, you can use the Autel J-Box for your VCI and connect it to a Windows based PC using a USB cable and log on to the GM w...
发表评论
阅读全文

Ford VCM II firmware update or downgrade

It’s confirmed that  Ford VCM II Firmware Update And Downgrade is possible, Operation steps guide here (This guide applies to all vcmii tools) Procedure: Remove the rubber case shown below. Connect the USB cable to the VCM2 device and hold the (ReSet) button shown as below. Connect the other end of the USB to a computer with IDS V86 installed, and then release the ReSet button until you hear a beep sound. Run Bosch\VCI Software(Ford-VCM-II)\VCI Manger(Ford-VCM-II). When you see the following image, it means you enter the recovery mode. After clicking on the “Recover” button, the program will switch to the VCMII Update interface. Click on “Start Update” to start the firmware update, and the following image will appear “Do not unplug the VCM II from the PC or remove power from the VCM II during the update process.” After clicking on “OK”, the following image will appear to start writing the new version of firmware. When the upgrade completed, the following pro...
发表评论
阅读全文